Manualshelf

Installation Guide

ManualsBrandsProgress Lighting ManualsCeiling Fan Light KitsFan Light Kits Collection 1-Light Forged Black Ceiling Fan Light Kit
12
SPEC.NO.
(01-06-09)022201
Assembly & Installation Instructions
Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
2601
CAUTION:
PAGE of1 2
**********************************************************************************************************************************************************
1
2
3
4
5
6
7
9
10
12
8
11
Net Weight:
2.17 Lbs. (0.98
Kgs.)
**********************************************************************************************************************************************************
13
1, 2, 8, 9 & 10
(NOT FURNISHED)
(NO INCLUIDA)
(NON FOURNIE)
WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full
compliance with N.E.C. requirements. If there are any questions, contact a Qualified Electrical Contractor.
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and /or
other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
1.- Remove the Switch Housing Cover (1) by removing the three Mounting Screws (2).
2.- Remove the Center Plug from the Switch Housing Cover (1).
3.- Remove the Hexnut (3) and Lockwasher (4) from the Stem (5) of the Light Kit Fitter (6).
4.- Insert the Light Kit Wires (7) thru the center hole of the Switch Housing Cover (1) and thread Cover onto the top of
the Light Kit Fitter (6). Replace Lockwasher (4) and Hexnut (3) onto Stem (5) to secure in place.
5.- Carefully pull down Blue and White Wires from the Switch Housing (8) (labeled "For Light Kit Connection"). Connect
Light Kit Wires (7) to Switch Housing Wires (9) (Black to Blue and White to White) by connecting male to female Quick
Connects (10). Take care to align tabs for secure fit.
6.- Align the screw holes of the Swich Housing Cover (1) with the screw holes of the Switch Housing (8) and secure with
the three Screws (2) removed in step 1.
7.- Install Lamp (13).
8.- Insert Glass Shade (11) into Fitter (6) and secure in place with the three Thumbscrews (12).
CAUTION - All glass is fragile, use care when handling Glass Shade and lamps.

Summary of content (2 pages)