Installation Guide

SPEC.NO.
(01-06-09)022388
Assembly & Installation Instructions
Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation.
2612
CAUTION:
PAGE of
1 2
***************************************************************************************************************************************************************
***************************************************************************************************************************************************************
1
2
3
4
5
13
7
9
10
11
8
12
14
15
6
16
WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full compliance with N.E.C. requirements. If there are any questions, contact a Qualified Electrical Contractor.
CAUTION - All glass is fragile, use care when handling Glass Shade and lamps.
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and /or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
WARNING - As required by Congress, this fixture contains a device to limit lighting power consumption to 190 watts or less. If the wattage of installed bulbs exceeds 190 watts, the light fixture will not operate. To reset the limiter (1) turn off power using the pull switch or wall switch, (2) reduce the total wattage of installed bulbs to less than 190 watts and (3) restore power to resume normal operation.
1.- Remove the Switch Housing Cover (1) by removing the three Mounting Screws (2).
2.- Remove the Center Plug from the Switch Housing Cover (1).
3.- Remove the Hexnut (3) and Lockwasher (4) from the Stem (5) of the Light Kit
Fitter (6).
4.- Insert the Light Kit Wires (7) thru the center hole of the Switch Housing Cover (1)
and thread Cover onto the top of the Light Kit Fitter (6). Replace Lockwasher (4) and Hexnut (3) onto Stem (5) to secure in place.
5.- Carefully pull down Blue and White Wires from the Switch Housing (8) (labeled
"For Light Kit Connection"). Connect Light Kit Wires (7) to Switch Housing Wires (9) (Black to Blue and White to White) by connecting male to female Quick Connects (10). Take care to align tabs for secure fit.
6.- Align the screw holes of the Swich Housing Cover (1) with the screw holes of the
Switch Housing (8) and secure with the three Screws (2) removed in step 1.
7.- Install Lamp (16).
8.- Slip Glass Shade (11) over Socket Nipple (12) and seat against Upper Cap (13).
Slip Lower Cap (14) over Nipple (12) and Secure Cap and Glass by Threading Finial (15) to Nipple (12). (FINGER TIGHTEN ONLY). Align Holes in Upper Cap (13) and Lower Cap (14).
9.- Slip Pull Chain from fan through holes.
10.- Attach wood pull tabs to chains.