OGRESS LIGHTING" P350246 3-LT SEMI-FLUSH CONVERT PACKAGE CONTENTS PART| DESCRIPTION | QUANTITY A | Fixture 1 B | Stem 1 Hanging mounting C | Canopy 1 Ceiling mounting HARDWARE CONTENTS (not actual size) : Screw (48-32) Qty Wire Nut Qty:3 Round Mounting Plate Qty:1 | Hex Nut | Cylinder Nut Qty:2 Qty (hr) J10lel Chain |Chain Loop| 12" Pipe | 6" Pipe | Nipple | Quick link| (Slinky (1/8IP) | (1/8IP) | (1/8IP)| (1/8IP) Qty:1 Qty:2 Qty:2 Qty:1 | Qty:3 Qty:1 F= "93164553 Page: THANK YOU for selecting Progress Ligh
/1\ Safety Information Please read and understand this entire manual before attempting to assemble, operate or install the product. CAUTION: Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation. CAUTION: Risk of fire. Min. 90°C supply conductors. Consult a qualified electrician to ensure comet branch circuit conductor. WARNING: If any Special Control Devices are used with this fixture, follow instructions carefully to assure full compliance with N.
Ceiling Assembly Instructions 3. Pass the wires through the stem (B) and the Canopy (C) . Attach the stem (B) onto the fixture (A), secure it tightly Strip 3/8” of insulation from the electrical wire ends. Using wire nuts (BB), connect RIBBED fixture wire to the WHITE supply wire from the outlet box; connect the SMOOTH fixture wire to the BLACK supply wire. Connect the fixture ground wire and supply ground wire using a wire nut or by fastening to the ground screw on the round mounting plate.
Hanging Assembly Instructions Canopy Parts Remove existing canopy parts from canopy Install canopy parts and chain loopy) into canopy (C), Secure tightly. od om a 83164553 Page NOTE: During this step, determine the hanging length of your fixture by adding or removing stems and chain links. The electrical and ground wire may also optionally be cut to length. Do NOT cut electrical or ground wires until this length is determined.
Hanging Assembly Instructions 9. Strip 3/8” of insulation from the electrical wire ends. Using wire nuts (BB), connect RIBBED fixture wire to the WHITE supply wire from the outlet box; connect the SMOOTH fixture wire to the BLACK supply wire. Connect the fixture ground wire and supply ground wire using a wire nut or by fastening to the ground screw on the round mounting plate. Push all wire connections into the outlet box. 10. Pass the screws through the two holes in the canopy.
