+PROGRESS LIGHTING” P500387 3-LT PENDANT PACKAGE CONTENTS PART| DESCRIPTION QUANTITY A | Fixture Shade 1 C | Diffuse Canopy assembly 3 E | Cord bushing 1 * NOTE: You have 3 complete Canopy Assembly finishes to choose from: -009 Brushed Nickel -31M Matte Black E—— n -163 Vintage Brass ©— HARDWARE CONTENTS (not actual size) Screw | Wire Nut | Round Mounting Plate | Hex Nut | Cylinder Nut | Strain Relief ay2 | Qs Gty:1 Qy2 Qy2 Qty:1 THANK YOU for selecting Progress Lighting We can assist you with questions reg
AN Safety Information Please read and understand this entire manual before attempting to assemble, operate or install the product. CAUTION: Read instructions carefully and tum electricity off at main circuit breaker panel before beginning installation. CAUTION: Risk of fire. Min. 90°C supply conductors. Consult a qualified electrician to ensure correct branch circuit conductor. WARNING: If any Special Control Devices are used with this fixture, follow instructions carefully to assure full compliance with N.
Assembly Instructions 93160648 Page:3 NOTE: Do NOT cut electrical or ground wires until this length is determined. Leave AT LEAST 6 inches MINIMUM of wire past the canopy {D) to allow for easy connections in step 4. 3. Choose the canopy (D) finish you like and then pass the wire through the cord bushing (E), out of the canopy assembly (D}. Loosen the strain relief set screw, pass the wire through the strain relief (FF) to adjust cord length. Once hanging length is determined, tighten set screw securely.
Assembly Instructions 6. Attach the shade (B) by sliding the "U" slot onto the fixture as shown (A). Using the cord bushing (E), secure the shade (B) tightly to the fixture (A). 6 Thread three lamps {not included) into the fixture sockets. Use 60-watt MAX incandescent medium base lamp, HSBC or SLED. 7. Following the 4 steps shown, place the diffuse {C) UP into the shade from the bottom {B) on an angle, then drop it down onto the perimeter wire.
