CRISSCROSS LIGHTING Assembly & Installation Instructions CAUTION: Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation. P6341 WARNING If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full compliance with N.E.C. requirements. If there are any questions, contact a Qualified Electrical Contractor.
Choice of Location: 1) The unit is designed to be mounted on a vertical surface 6 to 8 feet above the ground for optimum performance. 2) Whenever possible, locate the unit so that its coverage area is away from heat sources or reflective surfaces, such as heating vents, air conditioners, large moving trees or pools of water. 3) Whenever possible, locate the unit so that motion moves across the coverage area, not directly towards, or away from, the motion sensor.
MAHARAJAHS Consignes d’assemblage et d'installation NIRS MISE EN Lire attentivement les consignes et couper le courant a partir du GARDE : disjoncteur principal avant de commencer I'installation. Pe341 AVERTISSEMENT : Si des de commande spéciaux sont utilisés avec cet appareil d’éclairage, suivez attentivement les consignes afin d'assurer la conformité aux normes du Code national de I'électricité. Si vous avez des questions, contactez un entrepreneur-électricien qualifié.
Choix de I'emplacement L'unité a 6t congrue pour &tra installée sur une surface verticale situe entra 1,82 m of 2,43 m (entre 6 ot 8 pieds) au-dessus du sol pour une performance optimale. Dans la mesure du possible, placez 'unité de sorte que sa zone de couverture soit loin de toute source de chauffe ou de foute surface réfléchissante, telle qu'un chauffage, un appareil de climatisation, un grand arbre en mouvement ou une piscine.
Elección de la ubicación: 1) La unidad se ha diseñado para montarse en una superficie vertical metros pies) por encima del suelo para obtener un desempolvar optimo. 2) Siempre que sea posible, coloque la unidad de modo que su zona de cobertura esté alejada de fuentes de calor o superficies reflectan tes, como por ejemplo rejillas de calefacción, aparatos de aire acondicionado, arboles de gran mafioso o piscinas de agua.