Installation Guide

CAUTION:
Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation.
SPEC. NO.
93046942
06/21/2017
PAGE 1 OF 1
Do not make or alter any open holes in an enclosure of wiring or electrical components during installation.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Follow the Instruction carefully to assure full compliance with local, state, and NEC requirements. If there are any questions,
contact a Qualified Electrical Contractor.
WARNING: Risk of fire or electrical shock.
WARNING: To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
CAUTION: Risk of fire. Consult a Qualified Electrician to ensure correct wiring and connections.
NOTE: SUITABLE FOR DAMP LOCATIONS IN COVERED CEILINGS.
WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects and /or other reproductive harm.
Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
NOTE: Always install with ambient temperatures specified on the product specification sheet.
5 year warranty. See www.progresslighting.com for details.
1 INCH Ø REF
FLUSH CONNECTION
CONNECTOR
LINKING CABLE
BLIND CONNECTION
CONNECTOR
LINKING CABLE
KEEP THESE INSTRUCTIONS
Assembly & Installation Instructions
CAUTION: Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
P7510 Series
1. Read all instructions before installing fixture and keep these instructions in a safe place for future reference.
2. Only qualified electricians in accordance with local codes should perform all installations.
3. WARNING: PRIOR TO INSTALLATION MAKE SURE ELECTRICAL POWER SUPPLY FOR INSTALLATION CIRCUIT IS SHUT DOWN AT
ELECTRICAL SERVICE PANEL. DO NOT RE-ENERGIZE CIRCUIT UNTIL INSTALLATION IS FULLY COMPLETED.
4. This fixture is designed to be electrically grounded.
WARNING: TO PREVENT SHOCK CLOSELY FOLLOW GROUNDING DIRECTIONS.
INSTALLATION INSTRUCTIONS:
1. Select a suitable mounting location capable of supporting the fixture. NOTE: Make sure linking cable can be connected to unit in that location.
2. Place fixture up to mounting surface and mark position of 2 mounting holes on the surface with a pencil. The screw hole locations must be exact
for the fixture to mount properly. Mounting surface for the fixture should be a minimum of 3/8" thick wood.
3. Drill pilot holes just smaller than the screw diameter. Align mounting holes in fixture with pilot holes and drive screws into pilot holes,
tighten screws securely.
THIS UNIT MUST USE THE PROGRESS JUNCTION BOX P8740 AND PROGRESS LINKING CABLES. LINKING CABLES CONNECT
THE LIGHT FIXTURE TO THE JUNCTION BOX. LINKING CABLES COME IN FOURLENGTHS: P8733 IS 12 INCHES, P8735 IS 6 INCHES,
P8737 IS 18 INCHES, AND P8738 IS 24 INCHES LONG. A COUPLING CABLE P8743 CAN BE USED TO LINK CABLES TOGETHER IF
LONGER LENGTHS ARE NEEDED. COMPLETE INSTRUCTIONS COME WITH JUNCTION BOX AND LINKING CABLES.