OGRESS LIGHTING" P806A-N-MD-AT 6IN NEW CONSTRICT SLOPE NON-IX PACKAGE CONTENTS AIR TIGHT DORCAS PART| DESCRIPTION QUANTITY A | Fixture 1 This Instruction Sheet is also intended to be used as a Paint Shield. Upon completion of Installation, Crumple this Sheet up and Insert it up into the Housing to Protect the Socket and Labels from being Spray Painted. Remove Instruction Sheet and Socket Paint Cap prior to installing Trim and Lamp.
JN Safety Information Please read and understand this entire manual before attempting to assemble, operate or install the product. CAUTION: Read instructions carefully and tum electricity off at main circuit breaker panel before beginning installation. CAUTION: Risk of fire. Min. 80°C supply conductors. Consult a qualified electrician to ensure correct branch circuit conductor. WARNING: If any Special Control Devices are used with this fixture, follow instructions carefully to assure full compliance with N.
ASSEMBLY INSTRUCTIONS 2 2. Position Housing in desired location relative to the Bar Hangers and tighten the screws (6) to prevent further Housing movement. 3_ Lift the Leaf spring (8) of the junction box to unsnap the Junction Box Cover (7) . Run Supply Wires through UL Listed Connectors (not supplied) in one of the seven Tryouts (9} on the Junction Box {10}. Strip 3/8” of insulation from the electrical wire ends.
