Installation Guide

Page 1 of 1 93046403 REV. A
Assembly & Installation Instructions
PE010 / PE011
Ceiling Mounting
1. Connect 20” jumper leads to A/C input leads in J-box, fasten J-box bracket to J-box. Use BLACK wire for
120V, or RED wire for 277 volt, WHITE wire is common.
2. Fasten canopy to J-box bracket.
3. Snap housing to canopy.
4. Connect and trim input leads to socket leads at upper left corner of housing wire channel.
5. Secure face plate to housing. Remove the proper arrow as required.
Back Mounting
1. Connect 20” jumper leads to A/C input leads in J-box, fasten J-box bracket to J-box. Use BLACK wire for
120V, or RED wire for 277 volt, WHITE wire is common.
2. Remove necessary knockouts and fasten back cover to J-box.
3. Snap housing to back cover.
4. Connect and trim input leads to socket leads at upper left corner of housing wire channel.
5. Secure face plate to housing.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Do not let power supply cords touch hot surfaces.
2. Do not mount near gas or electric heaters.
3. Equipment should be mounted in locations and at heights where it will not readily be subject to tampering by unauthorized
personnel.
4. The use of accessory equipment not authorized by the manufacturer may cause an unsafe condition.
5. Do not use this equipment for other than its intended purpose.
6. Servicing of this equipment should be performed by qualified service personnel.
7. Do not use outdoors
INSTALLER:
•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
Warning:
Unused wires must be capped using enclosed wire nuts.
WARNING – This product contains chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm.
Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product