User manual

The pyrolytic cleaning
procedure cannot start:
• if you did not fully close the
oven door. In some models,
the display shows "C3" when
this error occurs.
CAUTION! If there are other
appliances installed in the same
cabinet, do not use them at the
same time as the Pyrolysis
function. It can cause damage
to the appliance.
During the pyrolytic cleaning the door is
locked. The symbol
and the bars of the
heat indicator come up, until the door
unlocks. The door unlocks when the
temperature inside the oven is under safety
conditions and the pyrolytic cleaning
finishes.
During the pyrolytic cleaning the lamp is
deactivated.
1.
Remove the worst dirt manually.
2. Clean the inner side of the door with hot
water, so that the residues do not burn
from the hot air.
3. Activate the appliance.
4. Set the Pyrolysis function (refer to
"Oven functions").
5. Touch .
6. Touch
or to set the duration of
the cleaning procedure:
Option
Description
1 1:00 h for a low
degree of dirt
2 1:30 h for a usual
degree of dirt
3 2:30 h for a high
degree of dirt
You can use the End function to delay
the start of the cleaning procedure.
7. Touch to activate the Pyrolysis
function.
Cleaning reminder
To remind you that the pyrolytic cleaning is
necessary, the cleaning reminder symbol
flashes in the display after each
deactivation of the appliance for the next 10
seconds.
The cleaning reminder goes
out:
• after the end of the pyrolytic
cleaning.
• when you deactivate it in the
basic settings. Refer to
"Using the settings menu".
Cleaning the oven door
The oven door has four glass panels. You
can remove the oven door and the internal
glass panels to clean them.
The oven door can close if you
try to remove the glass panels
before you remove the oven
door.
CAUTION! Do not use the
appliance without the glass
panels.
1. Open the door fully and hold the two
door hinges.
2. Lift and turn the levers on the two
hinges.
Progress 29