Operation Manual

To change the time of day touch again
and again until starts to flash.
Setting the DURATION
1. Set an oven function and temperature.
2. Touch
again and again until starts
to flash.
3. Use
or to set the minutes for
DURATION time.
4. Touch or the DURATION time starts
automatically after 5 seconds.
5. Use or to set the hours for
DURATION time.
6. Touch
. The DURATION time starts
automatically after 5 seconds.
When the set time ends, an acoustic signal
sounds for 2 minutes. and time setting
flash in the display. The appliance
deactivates.
7.
Touch a sensor field or open the oven
door to stop the acoustic signal.
8.
Turn off the appliance.
Setting the END
1. Set an oven function and temperature.
2. Touch again and again until starts
to flash.
3. Use or to set the END and
or to confirm. First you set the
minutes and then the hours.
When the set time ends, an acoustic signal
sounds for 2 minutes.
and the time
setting flash in the display. The appliance
deactivates automatically.
4. Touch a sensor field or open the oven
door to stop the acoustic signal.
5. Turn off the appliance.
Setting the TIME DELAY
function
1. Set an oven function and temperature.
2. Touch again and again until starts
to flash.
3. Use or to set the minutes for
DURATION.
4. Touch .
5. Use or to set the hours for
DURATION.
6. Touch , the appliance switches to
the setting of the END function.
The display shows flashing .
7. Use
or to set the END and
or to confirm. First you set the
minutes and then the hours.
Appliance turns on automatically later on,
works for the set DURATION time and
stops at the set END time. At the set time
an acoustic signal sounds for 2 minutes.
and the time setting flash in the display. The
appliance deactivates automatically.
8.
Touch a sensor field or open the oven
door to stop the acoustic signal.
9.
Turn off the appliance.
When the Time delay function is
activated, the display shows a
static symbol of the oven
function,
with a dot and .
The dot shows which clock
function is on in the Clock /
residual heat display.
Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set an oven function (or a programme)
and temperature.
2. Set the DURATION.
3. Touch again and again until
flashes in the display.
4. Touch
to set the SET+GO function.
The display shows and with an
indicator. This indicator shows which clock
function is activated.
5. Touch a sensor field (apart from ON /
OFF) to start the SET+GO function.
Setting the MINUTE MINDER
1. Touch .
and "00" flash in the display.
12 Progress