User manual

temperature inside the oven is under
safety conditions and the pyrolytic
cleaning finishes.
During the pyrolytic cleaning the lamp is
turned off.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Turn on the oven.
4. Set the Pyrolysis function. Refer to
"Oven functions".
5. Press .
6. Press or to set the duration of
the cleaning procedure:
Option Description
1 1:00 for a low de‐
gree of dirt
2 1:30 for a usual
degree of dirt
3 2:30 for a high
degree of dirt
You can use the End function to delay
the start of the cleaning procedure.
7. Press to confirm.
Cleaning reminder
To remind you that the pyrolytic cleaning
is necessary, the cleaning reminder
symbol flashes in the display after each
deactivation of the appliance for the next
10 seconds.
The cleaning reminder goes
out:
• after the end of the pyrolytic
cleaning.
• when you deactivate it in the
basic settings. Refer to
"Using the settings menu".
Removing and installing door
The oven door has three glass panels.
You can remove the oven door and the
internal glass panels to clean them. Read
the whole "Removing and installing door"
instruction before you remove the glass
panels.
The oven door may close if you
try to remove the glass panels
before you remove the oven
door.
CAUTION! Do not use the
oven without the glass panels.
1. Open the door fully and hold both
hinges.
2. Lift and turn the levers fully on both
hinges.
3. Close the oven door halfway to the first
opening position. Then lift and pull
Progress 31