User manual

73 progress
Fig. 32
Fig. 33
Clean the oven door with lukewarm water
and a soft cloth. Do not use products such as
scouring pads, steel wool, abrasive sponges
or acids because they could damage the
special heat-reflecting surface of the internal
panes of glass.
After cleaning, reassemble the panes in
the door and then the oven door, following the
procedure described above in reverse. Make
sure you reposition the panes correctly.
To perform this operation correctly,
proceed as follows:
a) the decorated middle pane with a frame
on the 4 sides must be reassembled so
that the screen-printing is facing outwards.
The side of the pane of glass is correct if
you do not feel any roughness near the
screen printing when you pass your fingers
over the surface.
The middle pane of glass must be put
back into the right seats as shown in Fig.
32.
b) the uppermost pane must be reassembled
as shown in Fig. 33.
After the panes of glass have been
reassembled in the oven door, perform the
procedure described in point 8. in reverse to
ensure they are locked.
Never clean the oven door when
it is warm as the panels might
shatter. If you can see scratches
or cracks in the glass panel, call
your nearest service centre
immediately to have the panel
replaced.
Models in stainless steel or aluminium:
Clean the oven door and operating panel
in stainless steel or aluminium with a damp
sponge and then dry carefully with a soft
cloth. Never use metal pads, metal wool,
acids or abrasives for cleaning because they
may scratch the surfaces.
)