User manual

72 progress
To programme the pyrolytic cleaning
cycle (delayed start, automatic stop)
If you desire, you can programme the
starting and ending time of the pyrolytic
cleaning cycle.
1. Use the button to switch on the oven.
Press the button
as often as
necessary, until the Pyro function symbol
(level 1 - P I) appears in the display.
Simultaneously the “Pyro indicator and
the symbol
will flash in the
display and an acoustic signal will be
emitted. This means that, before
activating the pyrolytic cleaning function,
you have to remove all the oven
accessories and the side rails from the
oven cavity (see the previous chapter).
2. The Cooking Time symbol
will flash
for some seconds; during this time push
the button ‘ ’ or ‘ ’ to select the
pyrolytic 1 (P I) or pyrolytic 2 (P 2) function.
3. Once you have chosen the desired
pyrolytic function, Pyro will flash in the
display waiting for confirmation to start
the pyrolytic cleaning function.
At this time, push the time function button
(Fig. 23). “The End of Cooking”
symbol
and the arrow symbol
flash. On the control panel, the cleaning
cycle (that is, the actual time + cooking
time) will displayed.
Press the ‘ ’ or ‘ ’ buttons to select the
required end of cycle time (Fig. 23). After
a few seconds, the word Pyro and the
symbol
will stop flashing, the
acoustic signal will stop while the
Cooking time symbol
will flash until
the pyrolytic cleaning cycle starts.
Fig. 23