User manual

To unlock the oven:
Press the
and “ ” at the same time and
keep them pressed for about 3 seconds.
An acoustic signal will be emitted and the in-
dication “SAFE” will go out.
The oven can now be operated.
Fast heat-up function
After a cooking function and the temperature
have been selected, the cavity will gradually
heat up until the selected temperature is
reached.
This will take from 10 to 15 minutes, depend-
ing on the selected function and tempera-
ture.
If it is necessary to reach the required tem-
perature in a shorter time, the “Fast Heat Up”
function can be used.
1. Switch the oven on by pressing button
.
2. Set the required cooking function and
temperature as explained in the previous
pages.
3. Set the temperature by pressing button “
" or “ ”. The temperature will appear
in the display.
4.
Press the button
. The temperature
display will show “ FHU ”
5.
Press the button
The symbol “ ° ” will
flash for approximately 10 seconds. Now
it is possible to select the required tem-
perature. To do this, press the button
“
” or “ ”.
6. When the required temperature is
reached, the electronic control beeps for
a short time, and the temperature display
reverts to the selected temperature.
This function can be used with any cooking
function or temperature.
Demo mode
This mode is intended to be used in shops to
demonstrate the oven functionality without
any power consumption except the interior
light, the display and the fan.
This function can only be switched on when
the appliance is first connected.
If there is a power failure, when the power
supply is restored again the Demo function
can only be switched on if, in the display,
12:00 and the symbol
are flashing auto-
matically.
1.
Press the button
for approx. 2 sec-
onds. A short acoustic alarm will be
heard.
2.
Press the bottons
and “ ” at the
same time. A short acoustic alarm will be
heard and the time 12:00 appears in the
display
12
When the oven is switched on, the symbol
appears in the display.
This means that the demo function is activa-
ted.
All oven functions can be selected.
The oven is not really working and the heating
elements do not switch on.
Switch off the oven and follow the above de-
scribed procedure to disable the demo
mode.
The demo mode remains saved in the
programme in the event of a power fail-
ure.
Beep on touch
You can choose to make the electronic con-
trol beep each time that a button is pressed.
To enable this function, the oven must be off.
1.
Press the buttons
and “ ” at the
same time and keep them pressed for
about 3 seconds. The alarm signal beeps
once
40 progress