User manual

2. the uppermost pane must be reassem-
bled as shown
After the panes of glass have been reassem-
bled in the oven door, perform the procedure
described in point 8. in reverse to ensure they
are locked.
Important! Never clean the oven door
when it is warm as the panels might
shatter. If you can see scratches or
cracks in the glass panel, call your
nearest service centre immediately to
have the panel replaced.
Models in stainless steel or aluminium:
Clean the oven door and operating panel in
stainless steel or aluminium with a damp
sponge and then dry carefully with a soft
cloth. Never use metal pads, metal wool,
acids or abrasives for cleaning because they
may scratch the surfaces.
Cleaning the oven door seals
A seal is fitted around the opening of the
oven.
Important! Check the condition of the
seal on a regular basis.
If you notice damage to the seal, please
contact the nearest service centre im-
mediately. Do not use the oven until the
seal has been replaced.
Replacing the oven light
Important! Separate the appliance from the
power supply by switching off the fuse.
If the oven bulb needs replacing, the new
bulb must have the following specifications:
– Electric power: 40 W
– Electrical rating: 230 V (50 Hz)
– Heat resistance up to 300 °C
– Connection type: E14
These replacement bulbs can be purchased
from your dealer.
To change the oven light:
1. Before proceeding ensure the oven is
cool and is disconnected from the elec-
tricity supply.
2. Push in and turn the glass cover anti-
clockwise
3. Remove the faulty bulb and replace with
the new one.
4. Refit the glass cover and restore the elec-
trical supply.
progress 51