User manual

6. Press the start button. The programme
starts.
Using the detergent
20
30
BA D
C
1.
Press the release button (B) to open
the lid (C).
2.
Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4.
If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
Using the combi detergent tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and
the rinse aid dispenser.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Press the on/off button to activate the
appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode
to start a programme.
Turn the programme knob until the symbol
of a programme is aligned with the on/off
indicator. If the on/off indicator comes on
and the start indicator starts to flash the ap-
pliance is in setting mode.
If the control panel does not show this con-
dition, press and hold the start button until
the appliance is in setting mode
Starting a programme
1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the symbol of a pro-
gramme you want to set is aligned with
the on/off indicator.
• The on/off indicator comes on.
• The start indicator starts to flash.
4. Press the start button to start the pro-
gramme.
• The on/off indicator and the start indi-
cator are on.
•The washing phase indicator comes
on.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the programme
1. Press and hold the start button until the
start indicator starts to flash.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed
comes on. If you do not deactivate the ap-
pliance within 5 minutes all indicators goes
off. This helps to decrease energy con-
sumption.
30 progress