User manual

4. Add the detergent.
• If you use the combi detergent tab-
lets, activate the Multitab option.
5. Set and start the correct programme for
the type of load and the degree of soil.
Using the detergent
20
30
BA D
C
1.
Press the release button (B) to open
the lid (C).
2.
Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4.
If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
Setting and starting a programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
The appliance is in setting mode when, af-
ter the activation, all the programme indica-
tors come on.
If the control panel does not show this con-
dition, press and hold, at the same time,
button
and button until the appli-
ance is in setting mode.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. To set a programme, keep the appli-
ance door ajar.
4. Press the button of the programme you
want to set.
• The related programme indicator
stays on while all the other pro-
gramme indicators go off.
• The duration of the programme flash-
es in the display.
•
The indicator
comes on.
5. Close the appliance door, the pro-
gramme starts. The programme dura-
tion starts to decrease with steps of 1
minute.
Starting a programme with delay start
1. Set the programme.
2. Press the delay start button again and
again until the display shows the delay
time you want to set (from 1 to 19
hours).
• The delay time flashes in the display.
3. Close the appliance door, the count-
down starts.
• The countdown decreases with steps
of 1 hour.
•
The indicator
goes off.
When the countdown is completed, the
programme starts.
•
The indicator
comes on.
You can set a programme, applicable
options and the delay start also with
the appliance door closed. In this con-
dition, you only have 3 seconds after
each setting before the appliance starts
to operate automatically.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press and hold, at the same time, but-
ton
and button until all the pro-
gramme indicators come on.
2. Set the programme again.
progress 31