User manual

Programme
1)
Degree of soil
Type of load
Programme
phases
Duration
(min)
Energy
(kWh)
Water
(l)
3)
Fresh soil
Crockery and
cutlery
Wash 65 °C
Rinse
30 0.9 9
4)
Normal soil
Crockery and
cutlery
Prewash
Wash 50 °C
Rinses
Dry
150 - 160 1.0 - 1.1 10 - 11
Normal or light
soil
Delicate crockery
and glassware
Wash 45 °C
Rinses
Dry
70 - 80 0.8 - 0.9 12 - 13
1) The pressure and the temperature of the water , the variations of the mains supply, the options and the quantity of
dishes can change the programme duration and the consumption values.
2) The appliance senses the degree of soil and the quantity of items in the baskets. It automatically adjusts the
temperature and quantity of the water, the energy consumption and the programme duration.
3) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
4) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery
with normal soil. (This is the standard programme for test institutes).
Information for test institutes
For all the necessary information for test performance. send an email to:
[e-mail]
Write down the product number (PNC) that is on the rating plate.
OPTIONS
Activate or deactivate the multitab op-
tion before the start of a programme.
You cannot activate or deactivate the
option while a programme operates.
Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the flow of rinse aid
and salt. The related indicators are off.
The programme duration can increase.
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode. Refer to ‘SETTING
AND STARTING A PROGRAMME’.
2. Press and hold function buttons (D) and
(E) at the same time until the multitab in-
dicator comes on.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse aid.
BEFORE FIRST USE
1. Make sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water
softener. Contact your local water au-
thority to know the water hardness in
your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the ap-
pliance. Start a programme to remove
progress 19