user manual Refrigerator PK1000
progress Contents Safety information Operation First use Daily use Helpful hints and tips 2 4 4 4 5 Care and Cleaning What to do if… Technical data Installation Environmental concerns 6 6 8 8 12 Subject to change without notice Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
progress 3 • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3.
progress Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
progress 5 gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Helpful hints and tips Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary.
progress Care and Cleaning Caution! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris.
progress 7 Important! There are some sounds during normal use (compressor, refrigerant circulation). Problem Possible cause Solution The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The lamp does not work.
progress 4. Replace the used lamp with a new lamp of the same power (the maximum power is shown on the lamp cover). 5. Install the lamp cover. 6. Tighten the screw to the lamp cover. 7. Connect the mains plug to the mains socket. 8. Open the door. Make sure that the lamp comes on. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Force Center.
progress 9 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician.
progress 90° 90° 2. Install the appliance in the niche. a) Push the appliance in the direction of the arrows (1) until the upper gap cover stops against the kitchen furniture. b) Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. 2 min 1 mm 1 Important! Remove the furniture door damper if possible, to provide free space for the free movement of the appliance door.
progress 11 Ha Hb Hc Hd 4. Attach the appliance to the niche with 4 screws. 7. Install the part (Ha) on the inner side of the kitchen furniture. ca. 50 mm 90° I 21 mm 90° ca. 50 mm 5. Attach the covers (C, D) to the lugs and the hinge holes. Attach the hinge cover (E) to the hinge. 21 mm 8. Push the part (Hc) on the part (Ha). Ha D C Hc E 6. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). 9. Open the appliance door and the kitchen furniture door at an angle of 90°.
progress Put together the appliance door and the furniture door and mark the holes. 8 mm Hb Ha 12. Press the part (Hd) on the part (Hb). Hb 10. Remove the brackets. Install the nail (K) 8 mm far from the outer edge of the door. 8 mm Hb Hd K Ha 11. Place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part Hb. Do a final check to make sure that: • All screws are tightened.
progress 13
progress
progress 15
www.progress-hausgeraete.
