User Manual Dishwasher PV1546
Progress CONTENTS Safety information Safety instructions Product description Control panel Programmes Settings 2 3 5 5 6 7 Before first use Daily use Hints and tips Care and cleaning Troubleshooting Technical information 9 10 12 13 15 18 Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage.
Progress 3 • • • • • • • • • • Do not change the specification of this appliance. The operating water pressure (minimum and maximum) must be between 0.5 (0.05) / 8 (0.8) bar (MPa) Obey the maximum number of 13 place settings. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard.
Progress • Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • This appliance complies with the E.E.C. Directives. • UK and Ireland only. This appliance is fitted with a 13 A mains plug. If it is necessary to change the mains plug fuse, use only a 13 A ASTA (BS 1362) fuse.
Progress 5 PRODUCT DESCRIPTION 1 2 11 10 1 2 3 4 5 6 9 8 7 Upper spray arm Lower spray arm Filters Rating plate Salt container Air vent 6 5 4 7 8 9 10 11 Rinse aid dispenser Detergent dispenser Cutlery basket Lower basket Upper basket 3 CONTROL PANEL 1 2 4 1 On/off button 2 Programme indicators 3 Indicators 4 Programme button 3
Progress Indicators Indicator Description End indicator. Salt indicator. It is always off while the programme operates. PROGRAMMES Programme 2) 3) 4) Degree of soil Type of load Programme phases Normal soil Crockery and cutlery • • • • Heavy soil Crockery, cut‐ lery, pots and pans Consumption values 1) Dura‐ tion (min) Energy (kWh) Water (l) Pre-wash Wash 50 °C Rinses Dry 227 1.039 11 • • • • Pre-wash Wash 70 °C Rinses Dry 155 170 1.5 - 1.
Progress 7 SETTINGS Programme selection mode and user mode When the appliance is in programme selection mode it is possible to set a programme and to enter the user mode. Settings available in the user mode: • The level of water softener according to the water hardness. • Activation or deactivation of the acoustic signal for the end of a programme. • Activation or deactivation of AirDry. As the appliance stores the saved settings, there is no need to configure it before every cycle.
Progress German de‐ grees (°dH) French de‐ grees (°fH) mmol/l Clarke de‐ grees Water softener level 11 - 14 19 - 25 1.9 - 2.5 13 - 17 3 4 - 10 7 - 18 0.7 - 1.8 5 - 12 2 <4 <7 <0.7 <5 1 2) 1) Factory setting. 2) Do not use salt at this level. Whether you use a standard detergent or multi-tabs (with or without salt), set the proper water hardness level to keep the salt refill indicator active. Multi-tabs containing salt are not effective enough to soften hard water.
Progress 9 CAUTION! If children have access to the appliance, it is advised to deactivate AirDry as opening the door may pose a danger. How to deactivate AirDry Make sure the appliance is in user mode. During the drying phase, the door opens automatically and remains ajar. CAUTION! Do not try to close the appliance door within 2 minutes after automatic opening. This can cause damage to the appliance. AirDry is automatically activated with all programmes excluding . 1. Press the programme button twice.
Progress CAUTION! Only use rinse aid specifically designed for dishwashers. 4. Carefully shake the funnel by its handle to get the last granules inside. 5. Remove the salt around the opening of the salt container. 6. Turn the cap of the salt container clockwise to close the salt container. CAUTION! Water and salt can come out of the salt container when you fill it. After you fill the salt container, immediately start a programme to prevent corrosion.
Progress 11 2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. • If the salt indicator is on, fill the salt container. 3. Load the baskets. 4. Add the detergent. 5. Set and start the correct programme for the type of load and the degree of soil. Using the detergent A B D Setting and starting a programme Standby mode The standby mode decreases energy consumption by automatically deactivating the appliance when it is not operating.
Progress Do not try to close the appliance door within 2 minutes after AirDry automatically opens it, as this may cause damage to the appliance. If, afterwards, the door is closed for another 3 minutes, the running programme ends. Cancelling the programme Press and hold the programme button until the appliance is in programme selection mode. Make sure that there is detergent in the detergent dispenser before you start a new programme.
Progress 13 2. Make sure that the salt and rinse aid containers are full. 3. Start the shortest programme with a rinsing phase. Do not add detergent and do not load the baskets. 4. When the programme is completed, adjust the water softener according to the water hardness in your area. 5. Adjust the released quantity of rinse aid. Loading the baskets • Only use the appliance to wash items that are dishwasher-safe. • Do not put in the appliance items made of wood, horn, aluminium, pewter and copper.
Progress 1. Turn the filter (B) counterclockwise and remove it. 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. Cleaning the spray arms Do not remove the spray arms.
Progress 15 • If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the appliance. To prevent this, we recommend to run long duration programmes at least 2 times per month. • To maintain the performance of your appliance at its best, we recommend to use monthly a specific cleaning product for dishwashers. Follow carefully the instructions on the packaging of the product.
Progress Problem and alarm code Possible cause and solution The appliance does not drain the wa‐ ter. • The end indicator flashes 2 times intermittently. • Acoustic signal sounds 2 times in‐ termittently. • • Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. The anti-flood device is on. • The end indicator flashes 3 times intermittently. • Acoustic signal sounds 3 times in‐ termittently.
Progress 17 The washing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • • • Poor drying results. • • • • • There are whitish streaks or bluish layers on glasses and dishes. • There are stains and dry water drops on glasses and dishes. • The dishes are wet. • • • • • • • Refer to "Daily use", "Hints and tips" and basket load‐ ing leaflet. Use more intensive washing programmes. Clean spray arm jets and filter. Refer to "Care and Cleaning".
Progress Problem Possible cause and solution There are residues of deter‐ gent in the dispenser at the end of the programme. • • • The detergent tablet got stuck in the dispenser and therefore was not completely washed away by water. Water cannot wash away the detergent from the dis‐ penser. Make sure that the spray arm is not blocked or clogged. Make sure that items in the baskets do not impede the lid of the detergent dispenser from opening. Odours inside the appliance.
Progress 19 Power consumption Off-mode (W) 0.50 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption. ENVIRONMENTAL CONCERNS not dispose of appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle materials with the symbol .
www.progress-hausgeraete.
