Owner manual

C2000
Installation
‚ 32
Installation Warnings
Warning:
Installation must comply with the National Electrical
Code, as well as Federal, State, Local and all applicable codes.
Warning:
High voltages are present in this equipment.
Disconnect all power before making installation to prevent
personal injury or equipment damage.
Warning:
Do not install C2000 units in a volatile, combustible or
explosive atmosphere. All C2000 units must be protected from
severe vibration, extreme temperatures and excessive humidity.
Any peripheral equipment is to be installed over a non-hazardous
location.
Any peripheral equipment connected to the C2000 must be UL
listed and using standard RS232 or RS485 communication.
The C2000
must
be plugged into a dedicated 115 VAC wall socket
with bonded earth ground.