User guide

PROHEAT INSTALLATION & SERVICE
6-6
Figure 6-9 Nozzle Components
CLEAN NOZZLE
BLOW THIS DIRECTION
WHEN USING
COMPRESSED AIR.
TORQUE TO
30±3 IN/LBS
(3.4±0.3 Nm)
HOLD
UPRIGHT TO
ASSEMBLE
REPLACE COMPRESSOR AIR FILTER
• Replace inlet air filter annually or more often
if dusty conditions are encountered.
TORQUE TO 50±5 IN/LBS (5.6±0.7 Nm)
•
Remove and install Nozzle as shown on page 5-12.
Torque to 150±10 in/lbs (17±1.1 Nm).
•
To properly clean the nozzle use electrical
c
ontact cleaner or warm soapy water
.
This will wash any dirt out and leave
no residue. When using compressed
air, blow into the nozzle orifice
from the head end.
Figure 6-10 Compressor Air Filter
6.2.10
6.2.9