User guide

Figure 3-20 Timer Connections
TI M E R
1
ON
2 3
BLACK
RED
W
HITE
G
REEN
BLACK
TIMER
SWITCH INPUT
HARNESS
RED
W
HITE
G
REEN
GREY
TO KEYSWITCH (OPTIONAL)
TIMER CONNECTIONS (OPTIONAL)
Black wire Ground
Red wire Power
White wire Operational signal from heater
Green wire “ON” Signal to heater
Grey wire Keyswitch backlighting (optional)
CAUTION
The switch input circuit should only
be used to supply power to the
ON/OFF Switch, the Timer, or as a
signal to trip a relay. Failure to
follow this installation practice will
result in damage to the PCM.
NOTICE
The PCM must be reset (power
disconnected and reconnected)
when changing from a Timer to an
ON/OFF Switch or from an ON/OFF
Switch to a Timer.
Do not connect an ON/OFF Switch
and a Timer in the same circuit.
3-12
PROHEAT INSTALLATION & SERVICE
3.5.3