Product Manual

7
CHARGING WITH PC400 BATTERY CHARGER
(240V AC CHARGING).
IMPORTANT: DO NOT POWER ANY APPLIANCE FROM THE JUMPSTARTER WHILE IT
IS BEING CHARGED USING THE AC CHARGER.
WARNING: SET THE VOLTAGE OF THE JUMPSTARTER TO 12V VIA THE HEAVY DUTY
VOLTAGE CONNECTOR.
1. To charge, set the voltage of the jumpstarter to 12V via the heavy duty voltage
connector and connect the supplied PC400 wiring harness to the cigarette lighter socket
on the front of the jumpstarter.
2. Connect the other end of the wiring harness to the PC400 battery charger supplied,
as per the below illustration.
3. Connect the PC400 battery charger to a 240V AC outlet and set to NORMAL
(battery type) and 4 AMP (charge rate).
WHEN TO CHARGE
Your jumpstarter is shipped fully charged, however, an extended period of time may
elapse in shipment or storage before the jumpstarter is purchased. Therefore you should
charge the jumpstarter before using it for the first time. It is recommended to charge
after each use. If the jumpstarter is not being used, it is recommended to leave the
jumpstarter permanently on charge ensuring the battery is always maintained fully
charged and ready for use.
HC3000 instruction Manual_1 15/11/11 1:45 PM Page 7