Product Manual

9
USING THE JUMPSTARTER AS A POWER SUPPLY
WARNING: ENSURE THE JUMPSTARTER IS SET TO 12V WHEN POWERING 12V
APPLIANCES. IF SET TO 24V THIS MAY CAUSE DAMAGE TO THE APPLIANCES.
The jumpstarter utilises 2 x 31Ah AGM batteries and can be used as a power supply
by connecting a cigarette lighter plug into the DC socket located on the front of the
jumpstarter. It is recommended to check the battery capacity before using the jumpstarter
as a power supply.
Below is a list of approximate run times for various appliances.
TYPICAL APPLIANCE RUNNING TIMES
Appliance Estimated power
Estimated time*
consumption (Watts)
(Hours)
Car phones, fluorescent lights 4 110
Radios, depth finders 9 75
Fridges (portable compressor style) 14 55
Camcorders, portable TVs 15 45
Electrical tools, bilge pumps 24 25
Cooler/warmers, spotlights 48 11
Air compressors, car vacuum cleaners 80 5.5
*Estimated time is based on a fully charged jumpstarter
Note: The jumpstarter can be used to power 24V appliances. Ensure the 12/24V
SELECTION SWITCH is set to 24V when powering 24V appliances.
IMPORTANT: AUTO-RESET CIRCUIT BREAKER FOR DC OUTPUT
The 12V DC socket is protected with an automatic resetting circuit breaker. When the
output experiences a short circuit or overload, the circuit breaker will trip, cutting off the
power temporarily. After a few seconds, the circuit breaker will automatically reset and
provide power again.
HC4500 instruction Manual_1 15/11/11 11:20 AM Page 9