Manual

23
CURRENT
– press the “CHARGE RATE” button (fig. A.23) until the desired value, set as
indicated in step 6, appears on the display (fig. A.4) and on the icon (fig. A.6).
The set current mode will be exited automatically after a 3” time-out.
PROCEDURE
– press the “MODE” button (fig. A.22) to select this desired function (fig. A.13
or fig. A.12); - if necessary or requested by the vehicle manufacturer
specifications, customise the voltage and/or current values as indicated below;
– use the “BATTERY VOLTAGE” button to select the battery voltage;
– connect the clamps to the relative vehicle battery terminals;
– the process will run automatically indicating the voltage value on the
display (fig. A.2), along with the current (fig. A.4) after 5 seconds from the
last operation.
2.5.2 SUPPLY
Constant voltage generator that can be used on BATTERY CHANGES or on batteries
with a very low voltage (below 2V) to try to increase their voltage to a value that is
suitable for starting with a normal charge cycle.
ATTENTION! The set voltage is always present on the charge clamps even
when disconnected from the battery.
ATTENTION! Pay particular attention to the nominal voltage of the battery
which must correspond to the voltage selected using the “VOLT” button
and indicated on the display (fig. A.1). This function DOES NOT HAVE spark
protection on the output clamps and reverse polarity protection.
BATTERY
VOLTAGE
CHARGE
RATE
CHARGE
RATE
VOLTAGE ADJUSTMENT – EXAMPLE
CURRENT ADJUSTMENT – EXAMPLE
3
BEEP
DISPLAY
13.3V
13.2V
13.1V
. . . . .
. . . . .
13.7V
13.6V
13.5V
3A 7A 10A 20A 30A 40A
►
3A 7A 10A 20A 30A 40A
DISPLAY
VOLTAGE ADJUSTMENT – EXAMPLE
3
BEEP
DISPLAY
13.3V
13.2V
13.1V
. . . . .
. . . . .
13.7V
13.6V
13.5V
3A 7A 10A 20A 30A 40A
►
3A 7A 10A 20A 30A 40A
MODE
MODE
BATTERY VOLTAGE
CHARGE
RATE
FUNCTION SELECTION
CURRENT ADJUSTMENT – EXAMPLE
DISPLAY – EXAMPLE
DISPLAY
VOLTAGE ADJUSTMENT – EXAMPLE
3
BEEP
DISPLAY
13.3V
13.2V
13.1V
. . . . .
. . . . .
13.7V
13.6V
13.5V
3A 7A 10A 20A 30A 40A
►
3A 7A 10A 20A 30A 40A
MODE
MODE
BATTERY VOLTAGE
CHARGE
RATE
FUNCTION SELECTION
CURRENT ADJUSTMENT – EXAMPLE
DISPLAY – EXAMPLE