HEAVY DUTY DUAL BATTERY TRAY Tray Fitting Instructions to suit Auxiliary battery for TOYOTA 100 Series Years: 1998–2007 Models: 1HZ 4.2 Litre Diesel, 1FZ-FE – 4.5 Litre Petrol (Not suitable for V8 models) P/No.
IMPORTANT SAFETY INFORMATION Please read this instruction thoroughly before fitting the tray. This product is recommend to be fitted by a workshop or qualified mechanical person. WARNINGS • Before installation, make sure that the vehicle is stationary and the wheels chocked. • Be careful when laying wires, not to cause any electrical shorts or wire breakage. • After installation ensure the bonnet can close without hitting the newly installed battery and battery tray.
FITTING INSTRUCTIONS 1. Make sure that the vehicle is stationary, the engine is switched off and cool. Disconnect the negative battery terminal from the main battery. 2. Locate the area where the tray will be fitted. Ensure it is clear ready for the tray. Note the 6mm holes in the engine bay. 3. Place and bolt the tray into the Engine Bay, using the 2 x M6 Counter sunk bolts, washer and nuts on the underside.
. Fit the battery, J bolts and special top mount. Use the M8 bolt to secure the top mount to the radiator support and tighten nuts on the J Bolts. Note M8 captive nut already exists in radiator support. 5. Reconnect the negative battery terminal to the main starter battery or install the desired Dual Battery System. Before closing the bonnet make sure the battery and tray do not hit the bonnet.
NOTES 5
NOTES 6
NOTES 7
WARRANTY STATEMENT APPLICABLE ONLY TO PRODUCT SOLD IN AUSTRALIA Brown & Watson International Pty Ltd of 1500 Ferntree Gully Road, Knoxfield, Vic.
