HEAVY DUTY DUAL BATTERY TRAY Tray Fitting Instructions to suit Auxiliary battery for TOYOTA Landcrusier Prado 120 Series Years: 2003 to 2009 Models: 1KD–FTV, 3.0 Litre Turbo Diesel P/No.
IMPORTANT SAFETY INFORMATION Please read this instruction thoroughly before fitting the tray. This product is recommend to be fitted by a workshop or qualified mechanical person. WARNINGS • Before installation, make sure that the vehicle is stationary and the wheels chocked. • Be careful when laying wires, not to cause any electrical shorts or wire breakage. • After installation ensure the bonnet can close without hitting the newly installed battery and battery tray.
FITTING INSTRUCTIONS 1. Make sure that the vehicle is stationary, the engine is switched off and cool. Disconnect the negative battery terminal from the main battery. 2. Locate the area where the tray will be fitted. 3. Unclip wiring loom and bolt in supplied right angle bracket using 1 x M6 bolt and nut. Hole created after unclipping loom clip.
. Unbolt junction of earth wires from inner guard, discard bolt. 5. Fit the tray in position using 3 x M6 counter sunk bolts into captive nuts. 6. Using the long M6 bolt and washer replace earth strap and junction of wires together with the battery tray arm to the inner guard using M6 captive nut. 7. Drill 2 x 6mm holes through the mount on the tray and through the wheel arch.
8. Push through 2 x M6 bolts through the holes and the wheel arch then support plate on the underside of the wheel arch. Tighten M6 nuts. Support bracket underside of wheel arch 9. Place battery into position install supplied top mount, line up to top radiator support and using a 6mm drill, drill through into the metal of the radiator support. DO NOT follow through drilling as you will damage the head light. Secure top mount with M6 bolt and nut. 10.
NOTES 6
NOTES 7
WARRANTY STATEMENT APPLICABLE ONLY TO PRODUCT SOLD IN AUSTRALIA Brown & Watson International Pty Ltd of 1500 Ferntree Gully Road, Knoxfield, Vic.
