HEAVY DUTY DUAL BATTERY TRAY Tray Fitting Instructions to suit Auxiliary battery for TOYOTA HILUX / FORTUNER 126 SERIES Years: 2015 onwards Models: 2.8 Litre TDI P/No.
IMPORTANT SAFETY INFORMATION Please read this instruction thoroughly before fitting the tray. This product is recommend to be fitted by a workshop or qualified mechanical person. WARNINGS • Before installation, make sure that the vehicle is stationary and the wheels chocked. • Be careful when laying wires, not to cause any electrical shorts or wire breakage. • After installation ensure the bonnet can close without hitting the newly installed battery and battery tray.
FITTING INSTRUCTIONS 1. Make sure that the vehicle is stationary, the engine is switched off and cool. Disconnect the negative terminal from the main battery. 2. Bolt isolator mounting bracket to tray using 2 x M6 counter sunk bolts and nuts. 3. Place tray in position placing spacer washer underneath front hole in tray closest to guard. Without tightening, screw M6 counter sunk bolt to captive nut.
4. Line up other holes and using M6 bolt with nut and body washer secure rear arm closest to engine. 5. Install an M6 bolt through front of tray, secure with nut and body washer under guard. 6. Drill hole through guard at the rear of the tray closest to the guard and secure with M6 countersunk bolt, nut and body washer.
7. Free mould on top of guard and locate the top mount anchor bracket through existing slot in mould. Mark position on guard. Remove moulding. 8. Using top mount Anchor Bracket mark hole centre and drill two 9mm holes. Using a Rivet Nut gun install 2 x Nutserts (Supplied) in to top of guard. Insert M6 bolts and secure anchor bracket to top of guard. Top Mount Anchor Bracket must be installed to ensure warranty.
9. Remove fuse lid to gain clearance and install battery, this will be a tight fit. Secure with Special top Mount and J bolts with an M6 bolt and nut to secure to Top Mount Anchor Bracket. 10. Reconnect the negative battery terminal to the main starter battery. Before closing the bonnet make sure the battery and tray does not hit the bonnet. For assistance throughout the installation procedure please call our customer service representatives on 1800 113 443.
NOTES 7
WARRANTY STATEMENT APPLICABLE ONLY TO PRODUCT SOLD IN AUSTRALIA Brown & Watson International Pty Ltd of 1500 Ferntree Gully Road, Knoxfield, Vic.
