HEAVY DUTY DUAL BATTERY TRAY Tray Fitting Instructions to suit Auxiliary battery for TOYOTA LANDCRUISER 70 SERIES Years: October 2016 Onwards Models: 1VD-FTV 4.5 Litre V8 Turbo Diesel Wagon / Ute P/No.
IMPORTANT SAFETY INFORMATION Please read this instruction thoroughly before fitting the tray. This product is recommend to be fitted by a workshop or qualified mechanical person. WARNINGS • Before installation, make sure that the vehicle is stationary and the wheels chocked. • Be careful when laying wires, not to cause any electrical shorts or wire breakage. • After installation ensure the bonnet can close without hitting the newly installed battery and battery tray.
FITTING INSTRUCTIONS 1. Make sure that the vehicle is stationary, the engine is switched off and cool. Disconnect the negative terminal from the main battery. 2. Remover brackets on the inner guard holding 2 x “Injector Driver” Computers. Disconnect plugs one computer has 3 plugs and the other has 4 plugs. 3. Remove computers from brackets (brackets not re-used, but retain screws) 4a. Grab the Supplied Computer mount and see how it is going to be mounted using the 10mm hole at the top. 4b.
6b. Adequately resecure harness to one of the firewall studs, using an insulated ‘P’ clip (not supplied) or similar. 4 7. Bolt the short top mount support bracket into existing hole at the bonnet shut line between inner and outer guard, using 1 x M8 long bolt and nut. (Use a Philips screwdriver shaft down through the hole, feed the nut onto it and hold nut up in place, remove screw driver and replace with bolt). 8.
9. Manipulate wiring loom into wedged shaped space between firewall, inner guard and wheel arch to gain clearance for tray. 10. Place tray into position and bolt in upper arms with 1 x M8 short bolt for front arm of tray and 1 x M8 long bolt for rear arm of tray, the bolt needs to go through rear arm and the computer plate bolting to the inner guard captive nuts. The tray can be flexed slightly forward or back to aid clearance.
11. The fitter needs to ensure there is sufficient clearance between tray, wiring looms, fuel lines and air conditioning pipes. E.g. Ensure windscreen washer tube is not kinked or restricted when moving computers. 12a. Drill 3 x 6mm holes through the wheel arch, using the holes in the lower tray mounting plates as a guide. 12b. Fasten with 3 x M6 bolts, body washer and nuts. Washer and nuts to be on the underside of the wheel arch. 13. Place battery into tray.
NOTES 7
WARRANTY STATEMENT APPLICABLE ONLY TO PRODUCT SOLD IN AUSTRALIA Brown & Watson International Pty Ltd of 1500 Ferntree Gully Road, Knoxfield, Vic.