HEAVY DUTY DUAL BATTERY TRAY Tray Fitting Instructions to suit Auxiliary battery for MITSUBISHI TRITON & PAJERO SPORT Years: 2015 onwards Models: 2.4 Litre TD P/No.
IMPORTANT SAFETY INFORMATION Please read this instruction thoroughly before fitting the tray. This product is recommend to be fitted by a workshop or qualified mechanical person. WARNINGS • Before installation, make sure that the vehicle is stationary and the wheels chocked. • Be careful when laying wires, not to cause any electrical shorts or wire breakage. • After installation ensure the bonnet can close without hitting the newly installed battery and battery tray.
FITTING INSTRUCTIONS 1. Make sure that the vehicle is stationary, the engine is switched off and cool. Disconnect the negative and positive battery terminals from the main battery. 2. Remove main battery. Remove M6 bolt holding wiring loom bracket at rear of battery and discard bracket and battery box (if supplied). 3. Remove 2 x M8 nuts from Bosch relay and remove M8 bolt on brake line bracket on the lower firewall. 4.
5. Cable tie fuel line to heater hose. 6. Position Battery Tray in position.
7. Ensure tray sits on top of Bosch relay bracket. 8. Fit short M8 bolt in rear support arm of tray onto brake line bracket. 9. Fit M8 long bolt through vertical bracket with captive nut. 10. Fit 2 x M8 nuts on Bosch relay mount bracket.
11. Fit M6 bolt through hole at front of tray into captive nut. 12. Tighten all bolts and nuts and check clearance of all hoses and cabling. 13. Install battery and standard top mount. Ensure positive terminal is toward the front of the car. 14. Refit original battery and cables, refit top mount and secure. 15. Reconnect the positive terminal then the negative battery terminal to the main starter battery. Before closing the bonnet make sure the battery and tray do not hit the bonnet.
NOTES 7
WARRANTY STATEMENT APPLICABLE ONLY TO PRODUCT SOLD IN AUSTRALIA Brown & Watson International Pty Ltd of 1500 Ferntree Gully Road, Knoxfield, Vic.
