HEAVY DUTY DUAL BATTERY TRAY Tray Fitting Instructions to suit Auxiliary battery for Mazda BT50 B3000 Manual/Ford Ranger PJ–PK Manual Years: Jan 2007 – Oct 2011 Models: WLT – 2.5 Litre Turbo Diesel & 3.0 Litre Diesel P/No.
IMPORTANT SAFETY INFORMATION Please read this instruction thoroughly before fitting the tray. This product is recommend to be fitted by a workshop or qualified mechanical person. WARNINGS • Before installation, make sure that the vehicle is stationary and the wheels chocked. • Be careful when laying wires, not to cause any electrical shorts or wire breakage. • After installation ensure the bonnet can close without hitting the newly installed battery and battery tray.
FITTING INSTRUCTIONS 1. Make sure that the vehicle is stationary, the engine is switched off and cool. Disconnect the negative battery terminals from the main battery. 2. Your Auxiliary tray will be located between the passenger side headlight and air cleaner. Remove the rear M8 bolt with large flange located on inner guard where you will locate tray, in between the headlight and air cleaner and retain. 3. Move wiring loom from the same position. 4. Place tray in position.
8. Place Battery in tray. 9. Fit the J bolts and place the special top mount on the battery and J bolts. 10. Line up the top mount and drill 6mm hole in radiator support. 11. Fit the M6 Hex bolt through the hole and tighten the M6 nut on the underside. 12. Tighten the nuts on the J bolts. 13. Reconnect the negative battery terminal to the main starter battery or install the desired Dual Battery System. Before closing the bonnet make sure the battery, tray and J bolts do not hit the bonnet.
NOTES
NOTES 6
NOTES 7
WARRANTY STATEMENT APPLICABLE ONLY TO PRODUCT SOLD IN AUSTRALIA Brown & Watson International Pty Ltd of 1500 Ferntree Gully Road, Knoxfield, Vic.
