Manual

CHARGING INSTRUCTIONS

STEP 1 – CHECK THE ELECTROLYTE LEVEL

Prior to charging the battery, remove the vent caps and check the electrolyte level (not

required on sealed & maintenance free batteries). The electrolyte should be 6mm (1/4”)

above the battery’s plates. If low, top up with distilled water to the correct level and

refit the vent caps.

STEP 2 – CONNECT TO BATTERY

There are three options for connecting to a battery.

Step 2A – Connecting to a battery that is out of the vehicle

Step 2B – Connecting to a battery fitted to a vehicle

Step 2C – Permanent hard wiring connection to a battery

STEP 2A – BATTERY OUT OF VEHICLE

Connect the RED lead (battery clip) from the charger to the Positive (+) battery post.

Connect the BLACK lead (battery clip) from the charger to the Negative (-) battery post.

Connection out of vehicle