User`s guide

english

26User’s Guide - Basic setupF35/FL35

user’s guide - Basic setup

5.6.4 Attaching X-PORT™ modules

X-PORT™ modules are separately available for purchase and not included

with the base projector.

Switch off projector and disconnect power cord before attaching X-PORT™ module.

Before attaching any X-PORT module, please make sure you have the latest SW run-

ning on the projector. Please go to www.projectiondesign.com to download the current

SW and update the projector accordingly. See chapter 8 for details on how to upgrade

the projector SW.

The projector supports up to two X-PORT™ modules simultaneously:

- X-PORT™ 1 for additional image processing (X-PORT™ DCC120*). Left hand side.

- X-PORT™ 2 for additional connectivity (X-PORT™ 3G-SDI, X-PORT™ DisplayPort 1.1a

and X-PORT™ HDMI 3D*). Right hand side.

*X-PORT™ modules subject to availability.

To attach an X-PORT™ module, please follow this procedure:

A Remove cover plate, by removing the four screws.

B Attach module. Observe X-PORT™ 1 and 2 positions are different. Attaching X-PORT™

modules in the wrong position will leave the module non-functional, but it is not

destructive.

C Fix the four mounting screws securely.

* Features in the user guide pictures/drawings may be different from your projector depending on model/version.

Finally connect power cord and switch on projector.

The ﬁrst time after a module is attached, the projector will automatically update and

conﬁgure the module. This may take a few minutes. Please ensure that power

remains on during this period.

Remove 4

retainer screws

Mount X-PORT module

Fasten 4

module

screws