Specifications

adjust projector settings
41
getting started
2
mount projection lens, get to know the connector panel
Carefully mount the projection lens. Remove protection end caps on lens and bayonet mount, then insert, and turn clockwise until it stops and a click sounds. The
connector panel at the back features a wide range of connectors for all sorts of source connections. Decide which one(s) that meet(s) your requirement(s).
This Quick Start Guide has been design to aid in quickly getting started with using your new projector. If you require further help, or have further questions on the
detail in how to operate this unit, please refer to our web site in order to download full product documentation. You can also access FAQs, and download detailed
white papers in order to get to know the more specific product features and benefits.
Packaging contents:
Adjust zoom to set correct image size, shift to position correctly, focus for clarity, and any other desired setting, such as tilt or keystone. Note that keystone is very
rarely needed when using lens shift for positioning. Adjust image level with the front feet, and tilt with the rear foot.
5
adjust image and system settings
connect sources, connect power, power on
3
B
A
E
Change and adjust settings such as brightness and contrast, ceiling mount and rear projection display, as well as colour calibration, and other system settings by
using the remote control or through the menu system that is accessible from the on-board keypad.
6
power off and allow to cool dow n
To power off, press the power ( ) key once, and confirm by pressing again. Allow to cool down until all fans have stopped (a minimum of 30 seconds), and steady
amber indicator lights indicate the projector has been safely turned off. Disconnect any cables, sources and power cables before uninstalling the projector.
Make sure the projector is switched off, and not connected to power when connecting to sources. Connect video and computer sources, then insert the power
cable. Power up sources, including computers and video playback devices. Power up the projector by pressing the power key (
). A steady, bright indicator light
will indicate it is in operation. CAUTION! Connecting sources to a powered projector may result in product failure. It is recommended that the power cable connector
(projector-end) or the mains power socket are accessible whilst the product is in use to enable mains power to be disconnected or switched off when connecting
source devices. This should be considered during product installation.
>30 s
projector unit
cable kit
(optional)
documentation
A: Zoom B: Focus C: Shift Press to activate. Adjust with arrow keys. D: Lens shift (operated from back) E: Adjustable feet for levelling.
remote control
C
E
601-0111-04
Quick Start Guide
WUXGA / LED
1080 / LED
SXGA+
*
* Pictures show backpanel of projector with UHP lamps.
LED illumination projectors have one indicator lamp (LED), instead of two (LAMP 1, LAMP 2).
*
*
601-0110-04
please visit our web site to download full instruction manual, and find related information
userguides.projectiondesign.com