PT-1441 Cordless Drill Driver 14.4V User’s Manual 1st Edition, 2009 ©2009 Copy Right by Prokit’s Industrial Co., Ltd.
PT-1441 User’s Manual Please read this handbook carefully before using the tool General Safety Rules WARNING Read all safety warnings and all instructions Failure to follow all warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference The term “power tool” in the warnings refer to your mains operated (corded) power tool or battery operated (cordless) power tool. 1) Work area a) Keep work area clean and well lit.
PT-1441 User’s Manual d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. f) Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves away from moving parts.
PT-1441 User’s Manual 6) Service Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Special Safety Advice for Cordless Drill Only plug the Battery Charger in 230V for PT-1441F type and 120V for PT-1441A type mains. Recharge the Battery only with the provided charger.
PT-1441 User’s Manual Technical Data Model PT-1441A PT-1441F DC 14.4V One Gear Speed: 0-550rpm DC 14.4V One Gear Speed: 0-550rpm Φ0.8 ~ 10mm Steel: Ø 6 mm Φ0.8 ~ 10mm Steel: Ø 6 mm Concrete: Ø 8 mm Concrete: Ø 8 mm Wood: Ø10 mm Wood: Ø10 mm Torque Setting 21 +1Position 21+1 Position Output torque 7 N.M (MAX) Rated Voltage No-load Speed Range of Drill Bit sizes Max. Drilling Capacity Drive (Collet) 7 N.
PT-1441 User’s Manual Product Features Torque adjustment Operating trigger Forward & Reverse switch Battery Charger Battery Release Button Initial operation Insertion and Removal of Rechargeable Battery Ensuring the correct orientation between the battery and the battery compartment, insert the rechargeable battery into the machine. Do not apply force when inserting the battery. Insertion can be achieved easily and without resistance.
PT-1441 User’s Manual and then holding the lower ring, turn the locking ring in a clockwise direction to firmly tighten it. To remove the tool hold the lower ring of the chuck and turn the locking ring anticlockwise. Open the chuck until you can remove the tool Operating Trigger Use the operating trigger to start the machine and keep holding it for continuous operation. The rotation speed can be varied by depressing the operating trigger. The more the trigger is depressed, the faster rotation speed.
PT-1441 User’s Manual location. If the drill-hole is deep, the drill-bit may become jammed in the hole. In this event a high torque could damage the drill bit or the drill. If the bit becomes jammed, hold the machine firmly and immediately release the On/Off trigger. Switch to anticlockwise rotation, and use a low rotation speed to remove the jammed drill bit more easily. 4. Drilling in Plastic For drilling in plastic use a steel drill and follow the same instructions as for drilling in wood. 5.
PT-1441 User’s Manual Certificate Number: TW98/12323QA www.prokits.com.