Owner Manual

10
WALL HOOD INSTALLATION
STEP 2
Install Ceiling Chimney Bracket:
• Place the chimney bracket against the ceiling, matching the center
point of the bracket with the center line of the installation area.
• Mark the locations of the bracket holes on the wall and drill the holes
where the locations are marked.
• Insert wall anchors in the drilled holes and screw the bracket into
place. The chimney will mount to the bracket.
STEP 3
Hang Range Hood and Connect:
• Hang the hood on the mounting screws in place from Step1. Tighten
the mounting screws to secure the hood. The bottom of the hood
should match up with the the horizontal line marked on the wall.
• Drill holes in the back of the hood lining up with the wall studs that
have been previously marked.
• Secure the hood to the wall studs using the screws included in the
hardware bag.
• Attach the previously installed ductwork to the hood’s blowers,
taping it in place using duct tape or HVAC tape.
• Power the hood by connecting the three pronged plug to a nearby
electrical outlet or by hardwiring the hood to a power source.*
2
3
*Always consult an electrician before directly wiring a hood to a power source.