Owner Manual

17
UNDER CABINET HOOD PREPARATION
WHAT YOU WILL NEED
INSPECT RANGE HOOD
PREPARE DUCTWORK
Power Drill
Screwdrivers
Drill Bits
Tape Measure
Masking Tape
Pencil/Marker
Metal or Aluminum HVAC Tape
Level
Wall Anchors*
Scissors/Box Cutter
• Check the contents of your box. They should include:
Range Hood
Wall Mounting Bracket
Hardware Bag
Transition Duct (Applies to Specific Models)
• Plug in and test controls, lights, and fan.
• Inspect for any damage caused during shipping.
• Report any damage to Proline Customer Service within 14 days of
receipt of hood by calling 877.901.5530 or emailing
[e-mail]
• Do not install if the hood is damaged or you are unsatisfied with it.
*Range hood needs to be installed to secure studs or supports. Wall anchors can be used for
additional support and will vary depending on wall material and the weight of the range hood
being installed.
Plan where your ductwork will be located. Install the proper sized
ductwork and exterior roof or wall cap, depending on where you will
be venting your hood to the exterior. Ductwork should already be
punched through the ceiling and above cabinet, or back wall and ready
to hook up to the range hood before beginning installation. See venting
requirements above.