Owner Manual

UNDER CABINET HOOD INSTALLATION

First draw these markings on the installation area wall

• Center line of installation area

• Location of wall studs nearest to the center line. (One on each side)

STEP 1

Find location for mounting the range hood

• Trace the outline of your hood on a panel of its cardboard box.

• Find the mounting holes and center point of the hood (directly

between the mounting holes) and mark them on the cardboard panel.

• Carefully cut out the cardboard outline.

• Tape the cardboard cutout panel to the wall leaving a small gap

(roughly 1/8") below the bottom of the cabinet . Match the center point

with the center line of the installation area.

• Poke holes through the mounting points on the cardboard marking

the locations on the wall and remove the cardboard.

• Pre-drill the mounting holes where your marks are with the correct

size drill bit.

• Screw in mounting screws, leaving roughly a 1/4” gap. This gap will

be used to hang the hood in Step 3.