Owner Manual

INLINE BLOWER INSTALLATION

STEP 4

Attach Duct Work to the Blower:

• After installing the blower to the bracket, it is now time to install

the previously installed duct work to the blower. This may require

transition pieces (B) if your inline blower (A) does not match the

diameter size of ducting (C) you are using. See diagrams for Step 4.

• If your duct work set up does not require transition pieces proceed

to the next bullet point. Place the transition pieces (B) on both ends

of the blower (A). Using your drill, screw three self-tapping screws,

spaced evenly around the circumference of the transitions, through

the transitions into the blower. Generously wrap the seams of the

connections with Aluminum HVAC tape to seal any airflow that may

escape.

•Place the duct work (C) on both ends of the blower (A), or pre-

transitioned blower. Using your drill, screw three self-tapping screws,

spaced evenly around the circumference of the ducting, through the

ducting and in to the blower or transition pieces. Generously wrap

the seams of the connections with aluminum HVAC tape to seal any

airflow that may escape.

3 x Self-tapping Screws