Service manual

SE R VICE MANUA L
PFL612W-U
Front Load W ashing Machine
Error message: The required wa ter level is not reac h ed wi thin 8 min, or the wa ter level excee ds the
protection value
Tr oubleshoo t ing:
N
Check if inlet valve is jammed
Clean inlet valv e
N
Dr aw out the di spenser and check if
wat
er is enterin g
Observe if th e
height of drain pi pe
not reac h 80 cm. If
water
level pres s ur e
sw
itch an d the hose
is leaking gas
N
T urn on power, and set pre- wash
mode, then star t. Check the impor t
vol t age of electromagnetic valve by
multimeter is it bet w ee n AC
220-240V?
Electromagnetic valve mus t be broken, pleas e
replace it.
N
Check if t ap is closed or water
pressure is too low (u s ua l
be tw een0.2 -1 MP a)
Open t he t ap or w ait for no rmal w at er
pressure to us e
The wire conne c ted PCB an d inlet valve is no t
proper ly . Please reconnect it or r e place it.
Y
Y
Y
Y
Y
Check if w ater is leaking from wa sher
bottom. Inlet pipe. drain pipe or
ot he r p i pe c o nn ection
Y
Replace PCB
Check if export vol t age from PCB to
electromagnetic valve, is it between
AC 220-2 4 0V?
N
N
Connect it well.