Operation Manual

Programmed play
By programming the player you can play up to 20 tracks in any desired order.
1. While the CD is in stop mode, press PROG.
• The PROG. indicator light and the number “01” will flash on the display.
2. Repeatedly press / to select the desired track number.
3. Press PROG. again to store the track.
4. Repeat the above steps until you have completed your program.
5. Press to commence play of selected tracks.
• Playback will start from the first programmed track.
You can repeatedly press / to select the desired track programmed.
To cancel the program play, press twice and the PROG. indicator light will go out.
HEADPHONE JACK
A PHONES jack is provided on the rear of the player so that you can listen
without disturbing others. To use this jack, plug in the headphones/earphones (not
supplied) and adjust the volume to a preferred level.
Note: When headphones/earphones are connected, the speakers of the player will be
muted.
AUX IN
Connect an audio cable (not supplied) to the AUX IN jack on the rear of the unit.
Connect the other end to a suitable output socket on your auxiliary device.
Set the FUNCTION switch to the CD/AUX position.
You can play music from an auxiliary device through the speakers of the player.
TROUBLESHOOTING
Problem
Possible Cause
Possible Solution
The player will not
play.
1.
Unit not in CD mode.
2. CD is not installed or installed
incorrectly.
1.
Select CD mode.
2. Load a CD with label side
up.
CD skips while
playing.
Disc is dirty or scratched.
Wipe the disc with a cloth or
use another disc.
Radio sound
distorted.
1. The station is not tuned in.
2. There is interference.
1. Fine tune the station.
2. Reposition the unit.
No radio sound.
1.
The unit is not in radio mode.
2. The volume is on the
minimum setting.
1.
Select radio mode.
2. Adjust the volume level.
GB-11
Downloaded from www.vandenborre.be