User manual

– clean the micro-fine filter and fine
strainer after each drying cycle;
– spin the laundry well before drying.
Energy consumption depends on spin-
ning speed set in washing machine.
The higher the spinning speed, the
lower the energy consumption.
INSTALLATION
Appliance positioning
• It is recommended that, for your conven-
ience, the machine is positioned close to
your washing machine.
• The tumble dryer must be installed in a
clean place, where dirt does not build up.
• Air must be able to circulate freely all
round the appliance. Do not obstruct the
front ventilation grille or the ventilation
grille at the back of the machine.
• To keep vibration and noise to a mini-
mum when the dryer is in use, it should
be placed on a firm, level surface.
• Once in its permanent operating position,
check that the dryer is absolutely level
with the aid of a spirit level. If it is not,
raise or lower the feet until it is.
• The feet must never be removed. Do not
restrict the floor clearance through deep-
pile carpets, strips of wood or similar.
This might cause heat built-up which
would interfere with the operation of the
appliance.
Important!
• The hot air emitted by the tumble dryer
can reach temperatures of up to 60°C.
The appliance must therefore not be in-
stalled on floors which are not resistant to
high temperatures.
• When operating the tumble dryer, the
room temperature must not be lower
than +5°C or higher than +35°C, as it
may affect the performance of the appli-
ance.
• Should the appliance be moved, it must
be transported vertically.
• The appliance must not be installed be-
hind a lockable door, a sliding door or a
door with hinges on the opposite side to
that of the tumble dryer, in such a way
that a full opening of the tumble dryer
door is restricted.
Removing transport safety
packaging
Caution! Before use all parts of the
transport packaging must be removed.
1. Open loading
door
2. Pull off adhesive
strips from inside
machine on top of
drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
Electrical connection
Details on mains voltage, type of current
and the fuses required should be taken
from the rating plate. The rating plate is fit-
ted near the loading aperture (see “Product
description” chapter).
Warning! The manufacturer declines
any responsibility for damage or injury
through failure to comply with the
above safety precautions.
Should the appliance power supply ca-
ble need to be replaced, this must be
carried out by our Service Center.
22