User manual

•
Water reservoir light: This light indi-
cates that the appliance is in the drying
phase. This light comes on at the end of
the programme to remind you that the
water reservoir must be emptied out. If
this light illuminates during a programme
this means that the water reservoir is full.
The buzzer sounds, the programme
stops, the light of the
Start/Pause but-
ton flashes. This light comes on also
when the water reservoir is not inserted
correctly.
•
Filter light: This light illuminates at the
end of the programme to remind you that
the filters must be cleaned.
•
Condenser light: This light comes on
every 80 cycles to remind you that the
condenser must be cleaned.
Changing programme
To change a programme which is running,
first cancel it by turning the programme se-
lector dial to
. Select the new pro-
gramme and press the
Start/Pause but-
ton.
Important! Please note that you can
change a running programme only during
the first five minutes, as the temperature of
the appliance is not too high.
At the end of the programme
If the laundry is not removed at the end of
the cycle, the dryer performs an anticreas-
ing phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer
will stop automatically at the end of the an-
ticreasing phase. Lights
End of pro-
gramme,
Filter and Water reservoir
remain lit and the buzzer sounds for 2 mi-
nutes.
Turn the programme selector dial to
to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty.
Leave the door open to prevent the forma-
tion of mildew and unpleasant smells.
If you open and then close the door
before turning the programme selector
dial to
all the lights corresponding to
the phases making up the performed
programme come on.
After each use
• Clean the filters.
• Empty the water reservoir.
CLEANING AND MAINTENANCE
Cleaning lint filters
To ensure that the appliance works perfect-
ly, the lint filters in the door and in front of
the drum must be cleaned after every dry-
ing cycle.
Caution! Important. Never operate the
dryer without the lint filter or with a
damaged or blocked lint filter.
1. Open loading door and remove laun-
dry.
2.
Use a damp hand to clean the micro-
fine filter, which is built into the lower
part of the loading aperture.
3.
After a period of time, a patina due to
detergent residue on laundry forms on
the filters. When this occurs, clean the
filters with warm water using a brush.
Remove the filter from the door pulling
29