User manual

Drum volume 108 l
Weight of the appliance 40 kg
Laundry: max. weight 7 kg
Type of use Household
Ambient temperature Min. 5 °C
Max. 35 °C
Energy consumption
1)
kWh/cycle 4,60 kWh
Annual energy consumption
2)
547 kWh
Energy efficiency class C
Power consumption Left-on mode 0 W
Off-mode 0 W
1) With reference to EN 61121. 7 kg of cotton and a spin speed at 1000 rpm.
2) Energy consumption per year in kWh, based on 160 drying cycles of the standard cotton programme at full and
partial load, and the consumption of the low-power modes. Actual energy consumption per cycle will depend on
how the appliance is used (REGULATION (EU) No 392/2012).
MACHINE SETTINGS
Setting Implementation
BUZZER always off 1. Turn the programme selector to any programme.
2.
Press simultaneously the
DELICATE and LONG ANTI-
CREASE buttons and hold down for approx. 5 seconds.
3.
The buzzer is now always off by default.
Water hardness
Water contains, a variable
quantity of limestone and min-
eral salts of which quantities
vary according to geographi-
cal locations thus modifying its
conductivity values.
Relevant variations of the con-
ductivity of the water com-
pared to those prefixed by the
factory could slightly influence
the residual humidity of the
laundry at the end of the cy-
cle. Your dryer allows you to
regulate the sensitivity of the
drying sensor based on con-
ductivity values of the water.
To know your water hardness, please refer to your water bill
or get information from your water supplier.
1. Turn the programme selector to any programme.
2.
Press simultaneously the
LONG ANTI-CREASE and
START/PAUSE buttons and hold down for approx. 5 seconds.
Lights show the current setting:
–
- low conductivity <300 micro siemens/cm
–
- medium conductivity 300-600 micro siemens/cm
–
- high conductivity >600 micro siemens/cm
3.
Press the
START/PAUSE button sequentially until you set
desired level.
4.
To memorize setting press simultaneously the
LONG ANTI-
CREASE and
START/PAUSE buttons or turn knob to OFF
position
SERVICE
In the event of technical faults, please first
check if you can remedy the problem your-
self with the help of the operating instruc-
tions - see chapter What to do if….
If you cannot remedy the problem on your
own, get in touch with the Customer Care
Department or one of our service partners.
To assist you quickly, these data are neces-
sary:
– Model description
– Product number (PNC)
– Serial number (S No. is on rating plate
stuck to the product - to find it see chapter
Product description))
– Type of fault
33