Owner's manual

-Disable: no Healthy Check function,

if without “Time Server” exist, this function will disable automatically

Healthy Check can be set up to test 3 different destination IP, in order to avoid

Wrong operation. ( in case destination server fail)

WAN TYPE

Three kinds of WAN types to let you select on each WAN port:

1. [Dynamic IP]

. connect to CABLE MODEM.

Obtain an IP address from ISP automatically.

Usually it's used to connect CABLE modem. You won't need to assign IP

Address, the Broadband Router will get the IP address for you

automatically.

2. [PPPoE] (Gateway / Basic NAT Mode only)

. connect to Dial Up DSL

Some ISPs require use of PPPoE to connect to their service.

Connect to ISP via dial-up connecting, ISP will assign a legal IP to you after

the user Id and password had been passed when the connection is made

(The user Id and password here are provided by your ISP.)

3. [Static IP]

. connect to Leased DSL

ISP assigns you a static IP address.

When used the leased line of ADSL. ISP will provide you the relative IP,

Subnet Mask, Gateway and DNS. You need to indicate the static IP

manually.

SCHEDULE

This function allow you to control each WAN port link up/down time by

daily/weekly

Start Time (hh: mm)

End Time( hh: mm)

Using 00 ~23 to indicate Hours.

Example 17:00 means 05:00 PM

Weekly: choose by day

Note: When enable SCHEDULE function, the Line will up/down following

the timer set, no matter DOD function is enable or not.

WAN SPEED: you need to enter speed of each WAN port (K bps)

Otherwise ROUTER will not work properly in

 Load Balance: Traffic Mode

 Bandwidth Usage Control

WAN Link Mode:

You can choose WAN port work mode with ADSL modem

Auto Sense

10Mbps Half Duplex