Use and Care Manual

Operating Instructions

Wet/dry vacuuming mode

1. Plug in unit and attach the hose connector into the air inlet. See picture ‘A’

below. Attach extension wand, if desired, to end of hose by pushing it firmly

into the hoses and firmly twisting. All hose and tool connections are attached

by friction fit method (shoving together and twisting to the right for firm

connection).

Attach additional wands or tools as desired. Switch the power on and start

vacuuming.

Note: the power switch is located on the top left side of the vacuum.

To turn vacuum on, (I) press up.

To turn vacuum off, (O) press down.

2. If the middle indicator turns green on the indicator screen, it indicates that the

appliance is powered on and working as it should.

3. If the red indicator light indicator is on, it means canister is full of dirt or

clogged. Switch off immediately when the light turns red.

Solution:

① Empty the dust canister (See “Unit Cleaning” below)

② Clean the HEPA filter and cloth filter (See “Unit Cleaning” below) or check

for clogs in the hose.

It is suitable to clean the dust canister and the filter regularly (every 15 to 30

days).

4. Left red light is the water full indicator. The unit stops sucking up when the

indicator turns red, meanwhile the motor will automatically turn the unit off. To

change simply unplug the unit and empty the water from the dust canister. (See

“Unit Cleaning” below) The unit will start again after replacing the dust canister.