Use and Care Manual

Blower Mode:

This appliance also functions as a blower, sprayer, and shampooer. Attach to the

blower hose to the outlet by inserting the gap in the tube plug to the hook of the

exhaust and turn 90 degrees. See picture ‘A’ below. Attach extension wand, if

desired, to end of hose by pushing it firmly into the hose. Attach additional wand

or tool, if desired, by firmly inserting onto the wand. Start the appliance and begin

blowing. Plug in the unit and push the power switch up to begin blowing.

Safety device:

1) The appliance has a protection device to automatically power off when the

water is full. It prevents water from reaching the motor. If this happens, the red

light will turn on indicating the tank needs immediate emptying.

2) A motor temperature protection device has been installed. When the

temperatures exceed the rated limit, it will power off for protection. If this

happens, clean filters and wait 30 minutes before reusing.

3) In the event of a clogged or full dirt tank, the red light will turn on indicating the

dirt tank and filter need cleaning. To ensure best performance, clean the tank and

filter every 15-30 days.

Using the Tools

Make sure the tools are secure to the hose or

wand before using.

1. Attach extension wand to end of hose by

pushing it firmly onto the hose and twisting.

2. Attach additional wand or tool, if desired,

by firmly inserting onto the wand and twisting.

3. Use the hose and wand alone or attach any

of the tools to the end of the hose wand.