Use and Care Manual

Assembly Instructions

1. Remove the dirt tank by pulling up on both handles to unlatch. Lift upper half of

unit to remove.

2. Remove all accessories and parts stored in the bottom of the tank prior to use.

3. If the round funnel comes out of dirt tank, set back inside the dirt tank

before reassembling.

4. To reassemble, place the top of the unit on the dirt tank so the edges fit

together and latch the handles to secure the top and bottom of unit.

5. Mount to wall (see instructions below).

Mounting & Installation Instructions

Mounting on drywall or plaster wall with stud (fasteners

included)

1. Locate a stud in your dry wall and drill a 1/8” pilot hole.

2. Mount the bracket with a #10-16 x 1-3/4” screw.

3. Ensuring your bracket is aligned correctly with the stud, drill a second pilot hole

using the next hole as a guide. Securely fasten with a screw.

4. Repeat step 3 for remaining hole.

Note: mount near a wall outlet, making sure the cord provided will reach the

outlet.

5. Mount the vacuum unit by making sure the square hole on the vacuum (#8 on

Page 5) slides over the bracket lip. Also see “Hanging the Unit” on Page 9

below.

See Mounting Images on the next page.