Use and Care Manual

Mounting on concrete wall (fasteners included)

You will need: (4) 3/8” x 2-1/4” concrete sleeve anchors. 4 holes

1. Drill a 3/8” x 1-3/4” hole with a masonry drill bit.

2. Insert a bolt and anchor sleeve into the hole.

3. Align the bracket over the hole and mark the remaining hole locations using the

(4) holes of the mounting bracket. Remove the bracket and drill remaining holes.

4. Mount the bracket starting at top corner hole, tightly securing sleeve anchor

with hex nut.

5. Repeat for three remaining holes.

6. Mount the unit by making sure the two square slots on backside of unit are

sitting on the two hooks on the mounting bracket.